Quick setup

Installed in 3 minutes.

Three steps, no tools. Here you'll find the video, instructions and safety notes.

Preparation
Line up the screens you want to connect side by side so that there's no vertical angle and no horizontal height difference. Make sure there's no gap left.
screenbuddy
Make sure the wings are connected by the magnet and the slider is in the innermost position (as delivered).
Installation
Stick one wing to the top edge (left edge if horizontal) of your screens and press it on evenly with sufficient pressure for about 5 seconds. Then stick the second wing to the bottom (right) edge of your screens the same way.
Set the angle
Rotate the front plate 90° counterclockwise to a vertical position for setting the desired angle. Locking the angle, by returning to the initial position.